Search Results

In this activity, learners explore the concept of how aerospace engineering has impacted sports, specifically exploring the design of golf balls.

In this activity (on page 2 of the PDF under GPS: Luge Activity), learners will construct a model hovercraft out of an empty spool and a piece of cardboard.

In this activity, learners explore motion, energy, and electricity by constructing bottle cars that run on motors.

In this activity, learners construct speedy vehicles made out of paper plates and powered by twisted rubber bands.

In this design challenge activity, learners build a rubber band-powered rover that can scramble across the room.

In this design challenge activity, learners build a device to carry a Ping-Pong ball from the top of a zip line to the bottom in four seconds (or less!).

In this activity, learners explore the concept of how brakes can stop or slow mechanical motion.

This activity (on page 2 of the PDF under SciGirls Activity: Luge) is a full inquiry-based challenge related to motion and design optimization.

In this engineering activity, challenge learners to design a car using only 3 straws, 4 Lifesavers™, 1 piece of paper, 2 paper clips, tape, and scissors.

In this activity related to Newton's Laws of Motion, learners build a boat powered by a propeller in the air.

In this activity, learners construct cars that are powered by hand-made, electric propellers.

In this physics activity, challenge learners to make a race-car out of a coffee can and rubber band. Demonstrate motion, forces, kinetic and potential energy and friction.