Search Results

In this indoor and/or outdoor activity, learners make an anemometer (an instrument to measure wind speed) out of a protractor, a ping pong ball and a length of thread or fishing line.

In this activity, learners engineer a flying glider using paper hoops and a drinking straw.

In this activity, learners explore the possibilities of clay as a natural material.

In this physics activity, challenge learners to make and race a balloon-powered car. Learners construct the body out of a paper cup, wheels out of wooden spools. and fuel tank out of a balloon.

In this activity, challenge learners to make a pencil stand on its tip using only two pieces of wire and two clothespins. Use this activity to demonstrate the center of gravity.

In this activity, learners discover how NASA engineers develop experimental aircraft.

This lesson plan revolves around studying the speciation of the Galápagos mockingbirds, which are on display at the California Academy of Sciences.

In this activity, learners explore the engineering behind seismographs and how technology has improved accurate recording of earthquakes.

In this activity, learners incorporate a simple switch into a battery/bulb circuit. Learners will use their knowledge of circuits to design and make their own switches using common materials.

Learners design their own experiment to explore the permeability of different materials such as soil, sand, gravel, and marbles.

In this team design challenge (page 2-10 of PDF), learners design and build a model of a Lunar Transport Rover that will carry equipment and people on the surface of the Moon.

In this activity, learners explore clouds and how they form.

Learners explore magnetism and motion as they build a simple marble run. Learners test different arrangements of plastic and cardboard tubes, bottles, and cups on a magnetic board.

In this activity, learners test the rate of ripening fruit and vegetables and use a chemical to inhibit the ripening process.

In this activity, learners explore how the process of folding has impacts on engineering and is evident in nature.

In this activity, learners work individually to assemble a product and then work in teams to design, construct, test, and redesign an assembly line process whose product must meet specific quality con

In this activity, learners explore scale by using building cubes to see how changing the length, width, and height of a three-dimensional object affects its surface area and its volume.

In this activity, learners explore how engineers have developed big wheels or Ferris wheels.

This activity encourages learners to focus on the natural environment of the Eastern Woodlands before the arrival of European settlers.

This activity (located on page 3 of the PDF under GPS: Garbology Activity) is a full inquiry investigation into design optimization using recycled materials.