Search Results

In this activity, learners explore how various energy sources can be used to cause a turbine to rotate.

This activity (on page 2 of the PDF under SciGirls Activity: Kites) is a full inquiry investigation into how a kite’s shape affects its performance.

Using a vertical wind tube and using simple materials, individuals and groups attempt to design a "satellite" that floats for at least 5 seconds.

In this engineering/design activity, learners make a kite, fly it, and then work to improve the design. Learners explore how their kite design variations affect flight.

In this activity, learners evaluate the potential performance of air rockets placed inside a wind tunnel.

In this outdoor activity, learners simulate an oil spill using popcorn (both oil and popcorn float on water), and estimate the spill's impact on the environment.

In this activity (page 1 of PDF under SciGirls Activity: Forecasting), learners will construct an air cannon by cutting a hole in the bottom of a bucket and stretching a garbage bag over the other end

In this weather forecasting activity, learners determine the location of cold and warm fronts on weather plot maps.

In this activity, learners create and experiment with wind tubes. These tubes are a playful and inventive way to explore the effect that moving air has on objects.

In this activity, learners design and build a simple wind vane —one of the oldest kinds of weather tools— and use it to show wind direction.

In this sunny day experiment, learners measure and compare how quickly light and dark colored materials absorb heat.

This activity (on page 3 of the PDF under GPS: Sailboat Design Activity) is a full inquiry investigation into design optimization.

In this physics activity (page 8-9 of the PDF), learners will explore wind energy. They will build their own windmill and see how energy from wind can be converted into a useable form.

In this thought-provoking activity, learners plan a hypothetical project to build and operate wind turbines in their community.

In this meteorology activity, learners build weather vanes using straws, paperclips, and cardstock.

This activity (on page 2 of the PDF under SciGirls Activity: Lift Off) is a full inquiry investigation into the engineering challenges of sending scientific sensors into space.

In this design challenge activity, learners build a tower that’s at least 12 inches high with two or more parts that move (spin, sway, or flap) in the wind.

In this activity, learners construct hand-held altitude trackers. The device is a sighting tube with a marked water level that permits measurement of the inclination of the tube.

In this activity, learners explore how anemometers work to record wind speeds and how the equipment has undergone engineering adaptations over time.

In this engineering activity, challenge learners to design a car using only 3 straws, 4 Lifesavers™, 1 piece of paper, 2 paper clips, tape, and scissors.