Search Results

In this activity, learners explore how various energy sources can be used to cause a turbine to rotate.

Make a kite out of a garbage bag, shower curtain, painting tarp--anything light, thin, flexible and plastic!

In this engineering activity, learners build a device (an anemometer) to measure how fast the wind is blowing.

In this activity, learners make a barometer, an instrument to measure change in air pressure.

In this oceanography and data collection activity, learners cast real time sea state conditions using buoys from NOAA's National Data Buoy Center.

In this indoor and/or outdoor activity, learners make an anemometer (an instrument to measure wind speed) out of a protractor, a ping pong ball and a length of thread or fishing line.

In this activity, learners explore watercraft engineering and sailing.

This activity (on page 2 of the PDF under SciGirls Activity: Kites) is a full inquiry investigation into how a kite’s shape affects its performance.

In this engineering/design activity, learners make a kite, fly it, and then work to improve the design. Learners explore how their kite design variations affect flight.

In this sunny day experiment, learners measure and compare how quickly light and dark colored materials absorb heat.

Learners build a wind turbine and test it to see how much energy is created.

In this online game, learners must purchase power plants for their city.

In this activity, learners explore how anemometers work to record wind speeds and how the equipment has undergone engineering adaptations over time.

In this design challenge activity, learners build a tower that’s at least 12 inches high with two or more parts that move (spin, sway, or flap) in the wind.

In this activity, learners will engineer three different parachutes to test how well each one works.

In this activity, learners construct hand-held altitude trackers. The device is a sighting tube with a marked water level that permits measurement of the inclination of the tube.

In this engineering activity, challenge learners to design a car using only 3 straws, 4 Lifesavers™, 1 piece of paper, 2 paper clips, tape, and scissors.

In this design challenge activity, learners build a tower that can support a tennis ball at least 18 inches off the ground while withstanding the wind from a fan.

In this activity, learners evaluate the potential performance of air rockets placed inside a wind tunnel.

In this activity (page 1 of PDF under SciGirls Activity: Forecasting), learners will construct an air cannon by cutting a hole in the bottom of a bucket and stretching a garbage bag over the other end