Search Results

In this activity, learners make "totally tubular" forms of carbon. Learners use chicken wire to build macro models of carbon nanotubes.

In this activity, learners explore how the hull shape impacts a ship's performance and stability.

If a sailboat is stranded because there is no wind, is it possible to set up a fan on deck and blow wind into the sail to make the boat move?

Groups of learners are provided with a generic car base and an egg. Their mission: design a device/enclosure to protect the egg on or in the car as it rolls down a ramp with increasing slopes.

In this activity, learners create a "Jam Jar Jet" based on Francois Reynst's discovery of a pulsejet engine, which uses one opening for both air intake and exhaust.

This is an activity (located on page 3 of the PDF under Water Clean-up Activity) about the use of reduction agents to decontaminate ground water.

In this team design challenge (page 19-24 of PDF), learners "land" a model Lunar Rover in a model Landing Pod (both previously built in activities #3 and #4 in PDF).

In this activity, learners build an electric two-paddle boat using paint paddles, plastic knives, and empty water bottles.

In this activity, learners build a sled kite that models a type of airfoil called a parawing.

In this activity, learners explore how various energy sources can be used to cause a turbine to rotate.

In this quick activity (page 1 of the PDF under SciGirls Activity: Tug O' War), learners will test how many pennies a flat paper index card bridging the gap between two stacks of books is able to supp

In this activity, learners will build the highest tower they can out of recycled materials.

In this activity, learners explore motion, energy, and electricity by constructing bottle cars that run on motors.

In this engineering activity (page 3 of PDF), young learners investigate how a pole can be made stable by “planting” its base in the ground or adding supports to the base.

How does a green roof, or roof covered by plants, affect the temperature of the inside and outside of a building? Learners design and build houses to find out the answer.

In this activity, PVC pipe, plastic water bottles and vinyl tubing are used to make a simple working toilet model. The model shows the role of a siphon in the flushing of a toilet.

In this activity, learners build small indoor paper rockets, determine their flight stability, and launch them by blowing air through a drinking straw.

In this activity, learners explore density and buoyancy as they design and construct rafts.

In this activity, learners investigate passive solar building design with a focus solely on heating.

In this activity, learners design, build and test wind turbines. Learners go through the design process and use the scientific method to test important blade variables.